Skip to content

Tutorials

Finger-joint box and dogbones

The sides and bottom of a plywood box joined by fingers and notches, with dogbones in every inside corner so that the square fingers fit in.

Open the example — the four sides of an 80 × 60 × 40 mm box joined by notches, and its bottom, in 6 mm plywood.

  1. Project: stock 230 × 120 × 6 mm. Measure your plywood: the notches must match its real thickness (often 5.8 mm for “6 mm” plywood).
  2. Sides: with the Path tool (L) and the grid, draw each side as a closed path. Their edges are split into five 8 mm bands: the front and back (80 × 40 mm) have fingers on bands 1, 3 and 5 and 6 mm notches on bands 2 and 4; the sides (60 × 40 mm), the opposite. The bottom (68 × 48 mm) is glued inside.
  3. Tool: the 3.175 mm 2-flute end mill.
  4. Outside profile of all the parts: 6.3 mm, 1 mm passes, 6 mm tabs.
  5. Dogbones: select the parts, then Drawing › Dogbones on Inside Corners: a round relief of the bit’s radius (1.59 mm) is cut into each inside corner of the notches, so that the square fingers fit in (see Radius, notches and dogbones). Create the profile first: it tells Dusty which side is material.
  6. Preview: about 17 minutes; in the top view, the dogbones show at the bottom of each notch.
  7. On the machine: see Before sending an example to the machine. Screws at the corners and in the middle of the long sides of the stock, clear of the parts. Try fitting two sides together before gluing.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.