Tutorials
Before sending an example to the machine
The checklist common to all tutorials: machine, tools, stock thickness, preview, workholding, zeros, framing and dry run, then a first start at 50 % feed.
Common to all tutorials. Try everything on the virtual CNC first.
- Machine: choose yours in the machine list (Machine tab in Dusty Studio). If its travel is smaller than a 3018’s, shrink the stock and move the shapes closer together.
- Tools: check in the Tools panel that the project’s tools are the ones you have: diameter, angle, number of flutes. The feeds come from the starter library, meant for a spindle of about 10,000 rpm: see the feeds and speeds calculator.
- Stock: measure its real thickness and enter it in the project setup; a through cut goes 0.3 mm into the spoilboard.
- Preview (⌥⌘P): the time, the simulated machined part and the pre-send check. Only the “the tool cuts into the spoilboard” warning is expected, for cut-outs.
- Workholding: as the example’s notes say, always clear of the toolpaths; the safe height (10 mm) must clear the clamps (see Travel heights).
- Zeros: home the machine if it has limit switches, X and Y zero at the front left corner of the stock (the origin of the examples), Z zero on the top of the stock, with a sheet of paper or by probing.
- Frame…, then Dry Run…: the job is played above the stock, spindle off (see Running a job).
- Start Job…: read the pre-send check again, accept the spindle start and lower the feed override to 50 % for the first try. Safety glasses, dust extraction, and a hand near STOP (see Safety).
- Tool change (two-tool examples): the machine stops, spindle off; fit the requested tool, set only the Z zero again, then Resume… (see Tool change).
Without a machine connected to Dusty, save the G-code (⇧⌘E) and send it with the software of your choice: see Saving the G-code.
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.