Tutorials
Key rings cut out with tabs
Three key rings cut out of 6 mm plywood with a 3.175 mm end mill: an outside profile, holes cut first, and tabs that keep the parts in place.
Open the example — three key rings cut out of 6 mm plywood: a rounded rectangle, a disc and a hexagon, each with a 6 mm hole for the ring.
- Project: File › New, stock 160 × 70 × 6 mm, origin Bottom left corner, Z zero Top of stock (see Project setup).
- Shapes: Rectangle tool (R), then in the Shapes panel width 50 mm, height 28 mm, corner radius 8 mm; Ellipse tool (E) with Shift for a 36 mm circle; Polygon tool (P) with 6 sides for a hexagon of 18 mm radius. In each part, a 6 mm circle at least 5 mm from the edge: these are the holes. Leave at least 10 mm between two parts (see Drawing tools).
- Tool: Tools panel › Add Tool › From Library › the 3.175 mm 2-flute end mill.
- Operation: select all (⌘A), then Operations › New Operation › Profile: side Outside, final depth 6.3 mm, depth per pass 1 mm, feed 600 mm/min. Dusty reads each inner circle as a hole: it is cut inside, before the outline of its part (see Profile).
- Tabs: check Tabs, length 6 mm (more than the bit’s diameter), height 1.5 mm. Dusty spreads them on the outer outlines, not on the holes; the Tabs tool (B) moves them (see Tabs).
- Preview: about 6 minutes; the machined part shows the bridges that hold the parts.
- On the machine: see Before sending an example to the machine. Clamp the stock at its four corners, or with double-sided tape over its whole surface. After machining, cut the tabs with a utility knife and sand.
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.