Skip to content

Getting Started

Coming from laser software

What carries over from laser software and what changes with a router: bit diameter, rounded inside corners, depth per pass, holding the stock, tabs and work zero.

Do you know laser cutting or engraving software? Many gestures carry over to Dusty: drawing, sorting shapes by color, framing the job, starting it, keeping the stop within reach. But a bit is not a beam: it has a diameter, it removes material as chips and it pushes the part around. What changes:

With a laserWith a router and Dusty
The beam has almost no width: the cut follows the line.The bit has a diameter (often 3 to 6 mm): its center runs beside the line, outside or inside the shape, or on the line (see Tool side).
Inside corners are sharp.An inside corner keeps the bit radius; for a square part to fit in, add dogbones (see Radius, notches and dogbones).
Power and speed set the depth.Depth is a dimension: final depth, depth per pass; the feed and the spindle speed set the cut (see Feed, speed and chip load). A thickness is cut in several passes.
A layer carries cut settings.A paint color carries shapes; an operation (profile, pocket, drill, V-carve…) says how to machine them and with which tool (see Creating an operation).
Fill (scanning).Pocket to clear an area to a depth, V-carving for crisp lines and letters, texturing for decoration.
The part stays put by its weight.The bit pulls and pushes: the stock must be held down (see Workholding) and cut-out parts keep tabs until the end (see Through cuts).
Focus on the surface.X, Y and Z work zero: the tool tip touches the top of the stock (or the spoilboard); the Z zero sets every depth (see Origin, zeros and coordinates).
A single “tool”.Several bits in one project, with a tool change between operations (see Tool change).
Smoke: extraction.Chips and dust: dust collection, glasses, hearing protection (see Safety).
On the left, the laser cuts on the line (red); on the right, the center of the bit (blue) runs one radius away from the drawing (dashed): the slot is as wide as the tool.
Inside corner: sharp with a laser (left), rounded to the bit radius (middle), cleared by dogbones so that a square part goes all the way in (right).

What carries over: framing before starting and the dry run (see Running a job), the job preview, STOP always visible. A LightBurn project (.lbrn2, .lbrn) opens in Dusty: shapes, texts, images and layers arrive in the paint colors, the laser settings are left out (see Importing); you then choose the operations and the tools. A GRBL controller set up for a laser ($32=1) must go back to router mode before machining (see Connection).

First habits: measure the stock thickness and enter it in the project, hold the stock down, take the Z zero on the top, start with a 3 mm flat end mill, 1 mm passes in plywood, and do a dry run before the first cut. The Coming from laser collection (see Collections) gathers the topics to read next.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.