Getting Started
First part step by step
Cut an 80 × 50 mm rectangle out of 6 mm plywood: project, drawing, tool, outside profile with tabs, preview, work zero, then framing and starting the job.
Example: cut an 80 × 50 mm rectangle out of a 6 mm plywood offcut with a 3.175 mm end mill. Try it first on the virtual CNC: everything works without a machine.
- Machine: at first launch, the Dusty tour has you choose your machine (see Add a Machine); No Machine Yet lets you start without one.
- Project: File › New (⌘N). The New Project window opens: stock 120 × 80 × 6 mm, origin Bottom left corner, Z zero Top of stock, then OK. See Project setup.
- Drawing: Rectangle tool (R), drag on the canvas, then type the exact width and height in the Shapes panel. Or import an SVG (⌘I).
- Tool: Tools panel › Add Tool › From Library › a 3.175 mm end mill. Its feeds and speeds will go into the operation.
- Operation: select the rectangle, then Operations › New Operation › Profile. In the Operations panel: side Outside, final depth 6.2 mm (slightly more than the thickness, to cut through), depth per pass 1.5 mm, Tabs checked so that the part stays held. See Profile and Tabs.
- Preview: ⌥⌘P. Read the estimated time and the pre-send check; only the warnings about going into the spoilboard (0.2 mm below the stock) are expected here. See Preview.
- On the machine: clamp the stock, connect the machine (Machine panel), home it if it has limit switches, bring the tool above the front left corner of the stock and set X and Y zero, then Z zero on the top of the stock (with a sheet of paper or by probing).
- Machine it: Frame… to see the footprint, then Start Job…: the pre-send check appears, then Start Machining… asks for your agreement (the spindle will turn). Stay near the machine, hand near STOP. See Running a job.
Without a machine connected to Dusty, save the G-code (⇧⌘E) and send it with the software of your choice: see Saving the G-code.
To go further, the tutorials rebuild eight ready-to-machine example projects step by step.
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.