Skip to content

Editing and arranging

Center line and one-pass engraving

Trace a line down the middle of each stroke instead of its outline, then engrave it in one pass with a bit of the stroke width, or a V-bit at the right depth.

With Center line, each stroke of the drawing (line art, handwriting, quilt pattern…) gives a line down its middle instead of its outline: open for a stroke with two ends, closed for a loop (circle, frame). Strokes that cross or meet give connected lines. The small branches that would run to the corners of a stroke or to the bumps of its edge are removed, at the scale of each stroke: a thin stroke keeps its details next to a thick one. A stroke end stops half a width from the edge, where the center of a bit as wide as the stroke stops; in a corner, the line cuts the corner slightly (less than one image pixel). A round dot, with no length, gives nothing.

The sheet gives the stroke width (median) to choose the engraving:

  • single-line engraving: Profile operation, On the line side, with a bit of that width;
  • V engraving: Profile on the line with a V-bit, at the depth where the groove is as wide as the stroke, that is width ÷ (2 × tan(angle ÷ 2)): 0.87 times the width with a 60° bit, half of it with a 90° bit (the sheet gives both). On open lines, the V-carving operation does the same: Limit maximum depth to that value (a closed line would be carved out like a shape there: keep the profile for loops).

To engrave strokes of varying width to their exact shape, V-carving the outlines (without center line) remains the most accurate.

Differences from MillMage: the stroke width and the suggested depths are Dusty’s own; the transparency boundary lies at half opacity.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.