Skip to content

Editing and arranging

Calculations in fields

Type a calculation in any number field: arithmetic, units converted on the fly such as 3/4" or 1ft 6in, and percentages of the current value.

Every number field (inspector, drawing, tools, operations, machine, settings) accepts a calculation, confirmed with Return or by leaving the field:

  • the four operations and parentheses: 100/3, 2*(10+5), =12.7+3 (a leading = is allowed);
  • units, converted into the field’s unit: 1in, 3/4", 1 3/4", 25.4mm, 2cm, 0.5m, 1ft 6in; in a field in inches, a number without a unit is in inches and 10mm stays in millimeters;
  • a percentage of the current value: 50% in Width gives half the width, 150% one and a half times (in a field already in %, 50% simply means 50).

The decimal comma is accepted in French (the point always is); in English, a comma followed by three digits separates thousands (1,000). An invalid entry (10+, abc, division by zero, a length unit in an angle or speed field) is refused: the field keeps its previous value and a message shows below it.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.