Skip to content

Dusty Link and Hub mode

Dusty Link security

What protects a shared machine: local network only, a pairing code on every request, confirmation on the sending device, STOP always allowed, no-go zones applied.

  • Local network only: private, link-local or loopback addresses; a request from the Internet is dropped without an answer. Never open port 46590 on your router.
  • Pairing code on every request; eight wrong codes change it (to read again on Dusty Link).
  • Confirmation on the device that sends for the spindle, every job and every resume; nothing starts on its own.
  • STOP and pause always allowed; if a device is lost during a continuous jog, the jog stops. Only the device that started a continuous jog holds it: another device cannot extend it. During a job, the machine goes on without the device (the controller runs the program on its own).
  • No-go zones: the machine and project zones apply here too. A job that crosses one is refused on submission, with its message, and the moves of the pendant go through the same check.
  • Stay near the machine while it cuts, as over USB: see Safety.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.