Dusty Link and Hub mode
Remote tool change, pause and stop
Tool changes, pause with retract and stops on a shared machine: the prompt shows on every device, and STOP is always allowed from any paired device.
Dusty Link runs jobs like the device connected to the machine:
- Tool change: at the job’s
T…/M6, the spindle stops and Z rises, then the prompt shows on every device (tool, steps, warning). The device that started the job can measure the new tool on the tool length sensor (if the profile has one) and resume, after the question asked on it. If that device has not shown up for a minute, another paired device can resume the suspended job. See Tool change. - Pause with retract: the machine finishes the moves already sent, raises Z, stops the spindle and the coolant; resuming goes back into position. Allowed from every device.
- Stopping the job: controlled stop (the machine comes to rest, position kept), spindle, coolant and accessories off; the job becomes resumable. STOP: immediate controller reset, always allowed, from any paired device.
The machining log, the controller settings backups and the checkpoint of an interrupted job are kept by Dusty Link itself (/var/lib/dusty folder).
This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us
Try it in Dusty, for free.
Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.