Skip to content

Dusty Link and Hub mode

Mobile pendant

Drive the shared machine from a phone next to it, with nothing to install: scan a QR code, jog, set zeros, probe, start, pause and STOP from the browser.

The mobile pendant drives the shared machine from a phone or a tablet, next to the machine, with nothing to install: a page served by Dusty Link and by the desktop app’s Hub mode, in the phone’s browser (Safari, Chrome), on the workshop network.

Opening it

Scan the QR code with the phone’s camera — the pendant opens already paired. The QR code is shown by sudo dusty-hub --pendant on Dusty Link, in the Hub mode section of the desktop app, in the shared machine section of Dusty Studio (Mobile Pendant (Phone)) and in the Dusty Link sheet on Mac and iPad. Or open http://workshop.local:46590/pendant (the Dusty Link address followed by /pendant) and enter the pairing code. The phone keeps the code; add the page to the home screen to find it again like an app.

The screen shows the machine state (idle, running, paused, alarm), the tool position (work coordinates large, machine coordinates small) and the STOP bar, always at the bottom of the screen, above everything. Two tabs:

  • Jog:
    • step (0.1, 1, 10 or 50 mm: one tap, one step) or Continuous: the machine moves as long as your finger stays on the key, and stops as soon as it lifts, the page is hidden or the connection is lost (Dusty Link stops it on its own half a second after the last news from the phone);
    • three speeds;
    • Zero X, Y, Z, XY, XYZ at the tool position;
    • Probe Z with the plate thickness (the machine profile’s by default), after a question: the machine moves down on its own until contact;
    • Home (after a question) and Unlock after an alarm.
  • Machining:
    • the running job: file, progress, line, elapsed and remaining time, feed and spindle;
    • Pause (with Z retract), Resume… and Stop Job… (questions asked on the phone);
    • the tool change prompt (with the new tool measured on the tool length sensor);
    • the speed overrides: feed and spindle in 10% steps, rapids at 25, 50 or 100%;
    • the Dusty Link queue: a job sent from the computer or the iPad is started here with Start Here…, next to the machine. The phone takes the job over; the start question is asked on the phone, and the phone is the one that can resume the job after a pause or a tool change.

The pendant follows the chosen language (EN/FR button) and switches from the dark theme (the default, high-contrast for the workshop) to the light theme (in sunlight) with the ☀ button. A browser cannot keep the phone screen on for an http page: set the phone’s auto-lock to a long delay while machining. The machine continues even if the screen turns off; STOP is one tap away as soon as it turns back on.

This manual is also built into Dusty: press F1, or open the Help menu, to read the topic for what you are doing. A mistake, a missing answer? Tell us

Try it in Dusty, for free.

Free CNC milling software: design, toolpaths and machine control. Mac, iPad, iPhone, Windows and Linux.